3
1
2
79 cm
t
ransport
:
Lifting equipment should always be used to move the machine. .
The machine must not be pulled or lifted by the bowl lift handle.
When the machine is moved, it should be in a vertical position at all times.
i
nstallation
,
adjUstments
and
fixinG
:
The ambient temperature around the machine must not exceed 45
o
C.
Especially for floor model -
Adjustments:
The height of the legs should be adjusted
so that the bowl on the bowl trolley
fits perfectly into the bowl arms.
The bowl arms should be at the correct height above the floor before the
machine is taken into use – see “
Condition 1” and Condition 2.
It is of the utmost importance that the machine’s legs are adjusted so that the
conditions described by the following sketch are met:
Condition 1:
The top of the mixer must be parallel to the floor. To ensure this you must measure the distance from the top of the ma
-
chine to the floor:
The dimension must be the same when measured at the front of the mixer
and at the rear of the mixer:
Condition 2
The mixer must be height adjusted so that the bowl on the bowl trolley fits exactly in the bowl arms:
Basically, the dimension from floor to centre of the knobs on the bowl arms must be 79 cm. If the bowl on the bowl trolley
does not fit exactly in the bowl arms at this dimension, adjust slightly on the front legs of the mixer
.
Especially for table model - fixing and adjustment
:
Kodiak 20 table model must be fixed to the table it is placed on.
Kodiak 20 table model is fixed with bolts in the two hind legs
.
Bolts with dimensions M10 x 20 mm + table top thickness and a
washer are used.
The table must be suitable for machine’s weight and operation.
Height adjustment:
If the table is not fully even, justifications can be made by adjusting
the two front legs.
The adjustment is made as described for the floor model - see
above.
To raise leg
turn
clockwise
To lower leg
turn
anticlockwise
Together with the mixer
comes a 32 mm fixed
spanner to be used for
adjustments.
