18.9.2007
Rev. 2.4
Installation
11
Where the feed water is particularly hard, you are advised to install a softener. Any solid
particles (e.g., sand) may be eliminated by installing a mechanical filter, which must be
periodically inspected and cleaned. These filters must be in compliance with the relevant
national standards in force.
Obs! The ice flake maker is equipped with two different valves for water supply and with
one valve for water outlet (see fig.).
1.
Water for ice produstion
2.
Water for condensation
3.
Water outlet
Insert the special seals in the two threaded ring nuts of the water charge pipe with witch
the automatic ice flake makes come supplied (see fig.) Without exerting excessive force
in order not to risk cracking the unions, firmly tighten a threaded ring nut on the outlet of
the solenoid valve located in the back of the ice flake maker. Insert other water outlet pipe
in the same way.
The other threaded ring nut must be screwed on the water tap.
Insert the water outlet pipe in the housing provided in the back of the ice flake makers (see
fig.).
