10/23 Electric heated boiling top units (600)
Sealed components must not be tampered
with.
To reach electrical components remove control panel.
Hot plates
– Remove control panel, remove the fixing protection
underneath the faulty plate and replace it.
Change-over switch
– Remove control panel and change the faulty
component.
USE AND MAINTENANCE
WARNINGS
Caution , appliance with hot surfaces!
The appliance is for professional use and must be
used by trained personnel. It is for the cooking of
food. Any other use of the appliance is considered
improper.
The installation and adaptation to other voltage
must be done by qualified and authorized installers.
In case of breakdown disconnect the main switch.
Sealed components must not be tampered with.
For repairs consult only authorized service centres
and ask for original spare parts only.
The manufacturer declines any responsability
if such obligations are not observed.
Carefully read this booklet and keep it in a safe place.
Before using the appliance carefully clean all the
surfaces that will come in contact with food.
USE
Hot plates
NOTE
Only use pans with flat bottom.
The change-over switch has the following settings:
0
off
1
minimum temperature
2
÷
5
intermediate temperatures
6
maximum temperature
To switch on heating of hot plates (pilot lamp on)
turn the change-over switch knob on the desired
working position.
Switching off heating
– Turn change-over switch knob on position
0
(pilot lamp off).
CLEANING
AND
MAINTENANCE
– Before any cleaning operation disconnect the
electrical supply (if present).
– Clean stainless steel surfaces daily with water
and non abrasive common detergents, rinse
well and dry thoroughly.
– Do not use iron scouring pads or chlorate
products.
– Do not use sharp objects which can scratch and
ruin the steel surface.
– Do not use corrosive products to clean the floor
under the appliance.
– Do not wash the appliance with water jets.
– Before a long period of inactivity disconnect the
main switch. Proceed to its thorough cleaning.
– At least twice a year, ask for the intervention of
an authorized technician authorized for checking
the appliance. It is advisable in any case to
stipulate a maintenance contract.
LIST
OF
PARTS
SUBJECT
TO
REPLACEMENT
– Change-over switch
– Knob for change-over switch
– Hot plates
– Pilot lamp
