2.11.2005
Rev. 1.5
Operation instructions
15
4.2
Operation procedures
4.2.1
Operating the control panel - General
When the appliance is started with the ON/OFF switch, all displays and indicator lights
on the control panel illuminate for a short time (display test). After that, 'On' remains on
the temperature display and the time on the timer display (if the kettle is fitted with a timer
function). The appliance is now ready for use.
The same logic is repeated in all button functions of the control panel.
Selecting/activating a function:
Press briefly the appropriate button and then set the value desired using the central
dial, for example:
The appliance waits for the value for three seconds (the selected display is blinking),
whereafter the appliance starts to perform the function according the set value. In some
functions, e.g. in automatic water fill, a second press is still needed to confirm and activate
the function before the function starts to operate.
Stopping/cancelling a function:
Press the appropriate button for a long time (approx. 2 seconds).
4.2.2
Tilting the kettle
It is not possible to tilt the kettle when the lid is closed. In case you try to tilt the kettle
with the lid in a closed position, a blinking 'Lid' message appears on the display.
Tilting the Proveno kettle is carried out by pressing the tilting button.
The kettle tilts as long as the button is held down. In case the "pull-back" function is on,
(see "Adjustment instructions, Setting customer specific parameters"), a slight reversing
movement occurs after the button is released, which decreases dripping of food from the
the spout.
In case the kettle is tilted to its extreme position, the reversing movement making the ket-
tle completely empty does not occur.
Tilting the kettle to the cooking position is carried out by pressing the up-
right position button.
For safety reasons (safety regulations), the reversing movement lasts only as long as the
button is pressed. The upright position button must be pressed so long that the reversing
movement stops and the kettle is in the cooking position. In case the kettle is not reversed
up to the cooking position, a blinking 'PoS' message appears on the display when you try
to switch the heating or mixing on.
Summary of Contents for PROVENO S 100
