2.11.2005
Rev. 1.5
Installation
36
1.
Support pillar
2.
Bearing unit
3.
Cover plate
4.
Mounting bracket for cover plate
5.
nut
6.
nut
Installing the kettle section
The kettle can be transferred from its transport pallet onto the installation frame in two
different ways.
The first alternative is to cut the longitudinal boards of the pallet and push the fork-lift
trolley below the kettle.
Care must be taken that the lifting arms of the fork-lift trolley do not hit the parts protrud-
ing from the kettle bottom, i.e. the mixing motor cover box (Proveno 40, 60, 80, 100) as
well as the drain and discharge pipes.
Furthermore, it is recommended to place e.g. plywood strips between the fork-lift trolley
and the kettle bottom. Before lifting, the transport support of the kettle's left-hand axle and
the support pillar are detached from the transport pallet. It should be observed that, owing
to the ball-shaped bearing, the kettle control pillar also moves sideways. It is advisable to
put a piece of foamed plastic or a rolled cellular board between the kettle and control pillar
so that they do not hit each other.
Summary of Contents for PROVENO S 100
