REV. 7/31/2018 INST95-3027
3
KIT ASSEMBLY
(Figure A)
KIT PREPARATION
(CONT.)
4.
Slide the
radio trim panel
into the
bottom opening of the factory
dashboard trim panel, then clip in the
top portion. Note, if the center bar of
the radio trim panel is bowed, file the
opening of the factory dashboard trim
panel to fit better. (Figure C)
5.
Cut the sub-dash to allow room for the
radio assembly. (Figure D)
Continue to Kit Assembly
(Figure C)
(Figure D)
1.
Secure the
radio brackets
to the radio
using the screws supplied with the
radio. (Figure A)
2.
Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess. Test the radio for proper
operation.
3.
Secure the radio assembly to the dash
using the factory screws.
4.
Reassemble the dash in reverse
order of disassembly to complete the
installation.
Remove
shaded area
