1.800.221.0932
|
2
DASH DISASSEMBLY
1.
Unclip the right side of the driver’s knee
bolster panel next to the center console
and let hang. (Figure A)
Note:
There is no need to completely
remove the panel.
2.
Unclip and remove the (2) silver side
trim panels from each side of the factory
radio. (Figure B)
3.
Unclip and remove the trim panel below
the climate control panel.
4.
Remove the (4) Phillips screws securing
the climate control panel and a/c vent
panel. (Figure C)
(Figure D)
(Figure A)
(Figure E)
(Figure B)
(Figure F)
(Figure C)
5.
Remove the climate control panel.
(Figure D)
6.
Remove the a/c vent panel. (Figure E)
7.
Remove the (4) Phillips screws securing
the radio, and then remove. (Figure F)
8.
If equipped with automatic climate
controls, remove the (2) Phillips screws
securing the climate module under the
radio. This module will be reused in Kit
Assembly.
Continue to Kit Assembly
