2
1.800.221.0932 MetraPowerSports.com
INSTALLATION
Bar Mounting
• Use a 13mm socket or box wrench to remove the (2) nuts that hold the
2 piece clamps together. (Figure A)
• Adjust the clamp for the appropriate bar diameter, place the rubber
protection strip around the bar in the location you want to mount the
clamps. (Figure A)
• Insert the threaded stud attached to each pod, through the holes of the
clamps (top and bottom), and tighten to snug.
(
Figure A
)
Mirror Mounting
• If your vehicle has traditional stalk mounted side mirrors, the BC-BTHSP
can be mounted using the supplied mirror mount brackets. (Figure A.2)
• Remove your mirror arms and place the mount bracket in between the
arm and the mount base of the vehicle.
• The brackets are universal, so trial and error may be necessary before
you find a good angle and location. Keeping it lose may help until your
final result is achieved.
• Attach the speaker pods to the brackets with the supplied washer and
nut. Adjust your angle and location, then tighten.
*Note: Over-tightening will result in damage to the threads, and or bars
• Route the wiring away from any moving parts so as not to hinder the
turning movement of the handlebars
• Proceed to wiring connections
(
Figure A.2
)
