12
If you have created and saved ACR systems, you can choose a system in your list of clients and
their systems. By choosing this, the placement of the sensors of your current system will be
lost.
All the necessary data is available, you don’t have to re-enter the data at each service:
4. Select the customer whose system you are
servicing.
5. Select the ACR system.
10. Observe the measured values in
‘All Values’.
• Choose existing ACR system
3. Select ‘Choose Existing ACR System’.
6. Change the data if necessary.
7. Check the targets.
8. ’Place sensors’ & ‘OK’.
9. ‘Save system’.
11. Consult Diagnosis. (see 4.2.)
12. Use the measured values in a
Measurement Report. (see 4.3.)
1. Go to ‘Main Menu’.
2. Select ‘ACR System’.
Main Menu
