21
• Vacuum Decay Test - VDT
The vacuum decay test gives you the possibility to follow up and log the legaly imposed Vac-
cum test.
This test is separted in 2 stages:
- Evacuation
- Vacuum Decay Test
2. Select ‘Vacuum Decay Test’.
3. Complete the Vacuum Decay Test Setup.
You must assign a vacuum sensor
You are free to choose to assign a:
- Temperature Sensor for the System
Temperature
- Target Vacuum Pressure
1. Select ‘Main Menu’ and select ‘Tests’.
4. Press ‘Start Evacuation’
You get the Vacuum Evacuation Status
5. When the wanted target vacuum is
achieved, stop de evacuation and start the
VDT by pressing ‘Start’.
6. End the VDT by pressing ‘Stop’.
You get the report.
7. Consulting the VDT:
- on the handheld can be done similarly as
a Measurement Report.
(See 4.3 - Measurement Report)
- on the PC can be done similarly as a
Measurement Report & Logfile.
(See 4.5 - Follow-up on PC)
When water is evaporating,
this will be shown.
Main Menu
