Power and Voltage Quality Trainer
AD 2
– MI 3399
145
Figure 4-3: General record settings
The instrument is now prepared for recording electrical system parameters, generated
by the Application Trainer. Please start the recorder by pressing the
F1 (“START”) key.
The recorder can be stopped anytime, by pressing the F1 (STOP) key.
After General recorder has been set, we are ready to run the recorder - by pressing F1
(START) key. Even though we have set it up to finish after 1 day, the recorder can be
stopped anytime by pressing the F1 (STOP) key.
While recording is active
, the user can evaluate recording parameters in the
TREND screen, which appears in each MEASUREMENTS submenu. Figure below
shows the voltage trend MEASUREMENT
U,I,f
TREND (press 2x key F4). Similar
trends can be obtained for power parameters in POWER menu, harmonics in
Harmonics menu, etc.
Figure 4-4: Showing voltage trend on the instrument
Finish recording after a few minutes, by entering the RECORDERS
GENERAL
RECORDER menu, and pressing the F1 (STOP) key. Stored records can be observed
on the instrument or transferred to PowerView. If we would like to analyse a record on
the instrument (while we are in the field), enter the RECORDERS
MEMORY LIST
menu. A list of available records will appear. Choose the record which you would like
to observe by pressing the
“VIEW” key, and then select the electrical system
parameters.
Summary of Contents for MI 3399
