Power and Voltage Quality Trainer
AD 2
– MI 3399
186
While recording is active
, user can evaluate all recording parameters in TREND
screens, which appears in each MEASUREMENTS submenu. The figure below shows
voltage trend (MEASUREMENT
Flicker
TREND (press key F4).
Figure 4-73: Showing flickers on the instrument
In order to get some values, the recorder should run at least 30 minutes. Finish the
recording after you get some useful values, by entering the RECORDERS
GENERAL RECORDER menu, and pressing the F1 (STOP) key. If the user wants to
observe recorded data on the instrument, enter the RECORDERS
MEMORY LIST
menu. Choose the latest record and then open it by pressing the
“VIEW” key.
Figure 4-74: Observing records through Memory List submenu
Power View provides several options to observe flickers. All measurements can be
accessed through the
“Flicker” node from the “Data Explorer”. Each measurement may
be presented in either chart or table presentation. An example is presented in the figure
below.
Summary of Contents for MI 3399
