MetriCorr
Slimline series
–
ICL-C & MasterLink Operation Manual
16 | 54
3.2.5
Assigning probes/sensors/components to the ICL-C
The ICL-C has two channels: Channel 1 (ER probes) and Channel 2 (Line Current Sensor).
At the bottom of the setup page, you can assign ER probes to Channel 1
(Probe 1)
and a LCS component to
Channel 2
(LCS Sensor)
using the drop-down list of probes you have linked to your account, see the
following section "4.5.1 Create Line Current Sensor".
ER probes for ICL-C will always be" Connected". Only Channel 2 on an ICL-MasterLink (a different product in the Slimline series) can
be configured as" Native" via a hardware jumper inside the unit. "Connected" means that the ER probe is connected to the "Pipe"
terminal. "Native" means that the ER probe is NOT connected to the "Pipe" terminal, which is used for corrosion measurements in
free air.
As shown below, probes/sensors can be 'Disabled' from the drop-down list for both channels. Assigning a
probe/sensor/component to a channel allows the ICL-C to take readings on that channel.
Probe 1 (ER probe)
Suppose an ERv2 probe is connected to the ICL-C. In that case, the unit will automatically detect the probe
serial number and the probe certificate data, which does not need any further action once the probe serial
number is displayed.
LCS sensor (LCS component)
Before you can assign an LCS sensor, you must create an LCS sensor certificate, a data-set typed in on the
webpage described in section "4.5.1 Create Line Current Sensor".
