MetriCorr
Slimline series
–
ICL-C & MasterLink Operation Manual
21 | 54
4.5
WebService - Line Current Sensor (LCS)
The "Line Current Sensor" (LCS) must be created in WebService under "Components" before the LC input
can be measured. Furthermore, a DC resistance must be typed into WebService to enable calculated DC
currents and graphs.
4.5.1
Create Line Current Sensor
Click on “Components”
-
> “R LCS”
The landing page "Your LCS Sensors" is shown below.
The list shows all your LCS Sensors. In this example, there are two LCS sensors, "LCS-FGA" and "min lcs.
Click on “Edit”
to edit an
already existing
sensor. See
next page.
Click on
“
Delete
” to
delete the
given sensor.
Click “Create Sensor” to create
a new sensor (LCS certificate).
See Figure 6 on the next page.
Click “ρ
table” to create a new
material (Resistivity table).
See section 4.5.2
