MetriCorr
Slimline series
–
ICL-C & MasterLink Operation Manual
8 | 54
3
Configuration
3.1
Switch on & Initial Communication
Once connected to the antenna and battery, push the
'Status/Control'
button ('E' in Figure 3) and release
(<0.5s). This will indicate the unit's current status/mode with a series of flashes on the LED built into the
button. Please refer to the LED flash patterns below.
*
The device is Off. 5 short (0.5 milliseconds) flashes per second for 5
seconds. This signal is triggered by a
short
(<0.5s) push on the push-
button.
Figure 4. LED flash indication
Mode / status
Description
Waiting
The device is active and waiting for the next measurement to be performed.
Short (50 milliseconds) flash every 8 seconds
Measuring
The device is performing a measurement
.
Longer flash (0.5 seconds) repeated every second.
Searching
The device is searching for a network
.
1 short (0.5 milliseconds) flash repeated every second.
Transmitting
The device is transmitting data to the WebService.
3 short (0.5 milliseconds) consecutive flashes repeated every second.
Off
The device is Off
.
5 short (0.5 milliseconds) flashes per second for 5 seconds.
