Chapter II
5000-count portable digital multimeter, with current input
17
∗
A PTC (positive temperature coefficient) resistor protects against permanent
overvoltages of up to 600 V during resistance, capacitance, continuity and diode
test measurements. This protection is reset automatically after overload.
∗
Two HBC fuses provide protection up to 600 V during measurements of intensity
type.
∗
An IP protection rating of 50.
1.3. Safety
devices
∗
The battery unit cannot be accessed without first disconnecting the measuring
leads.
∗
When measuring voltages above 24 V, the sign blinks
p
on the display.
∗
When measuring voltages above 10 A, the sign blinks
p
on the display and an
intermittent audible signal warns the user.
∗
If the maximum range is repeatedly exceeded, an intermittent audible signal warns
the user in V
LOW Z
, V
AC+DC
, V
DC
,
ADP
DC
, ADP
AC+DC,
50 mA
DC,
50 mA
AC+DC
,
10 A
DC
, 10 A
AC+DC
functions.
1.4. Warranty
This equipment is warranted against any defects of manufacture or materials according to
the general conditions of sale.
During the warranty period (3 years), defective parts will be replaced, the manufacturer
reserving the right to repair or replace the product. In the event of the equipment being
returned to the distributor or to a local agency, carriage to the centre shall be payable by
the customer. The warranty does not cover the following :
1. Repairs necessitated by misuse of the equipment or use in association with incompatible
equipment.
2.
Modification of the equipment or any related software without the explicit authorization of the
manufacturer.
3.
Repairs necessitated by attempts to repair or maintain the product made by a person not
approved by the manufacturer.
4.
Adaptation to a specific application not provided for in the specifications of the equipment or
the user manual.
5. Damage after a drop, a shock or flooding.
1.5.
Maintenance and metrological verification
Return your instrument to your distributor for any work to be done within or outside the
guarantee.
1.6.
Unpacking - Repackaging
This equipment has been fully checked out mechanically and electrically before shipping.
All precautions have been taken to ensure that the instrument arrives at its destination
undamaged. However, it is advisable to carry out a rapid check for damage sustained in
shipping. If there is any evidence of damage, make this known immediately to the
shipper.
!
Should you need to return the multimeter, preferably use the original packaging
and indicate the reasons as clearly as possible on an accompanying note.
"
Our products are patented in FRANCE and internationally and the logotypes are
registered. We reserve the right to modify specifications and prices as required by
technological improvements.
