Technical characteristics of the MX 5006
28
Benchtop multimeters, 6000 and 60000 points
Technical characteristics of the MX 5006 (continued)
Temperature
Protection: 1414Vpk
Particular reference conditions:
An internal temperature rise may have been caused by:
¾
measurement of a strong current for a long time,
¾
overload of the +COM input with the switch set to T° or
Ω
.
In this case, it is necessary to wait some time to recover the specified metrological
characteristics.
The multimeter must be at the temperature of the room. If not, recovering the
metrological characteristics may take up to 2h. Otherwise, there may be a
temperature offset, because the cold junction temperature reference is a little off.
If there is any doubt, it is possible to check by measuring a known temperature
(
#
example: ambient temperature) with the thermocouple.
Range
Operating range
Specified
measurement range
Resolution
Uncertainty (
±
)
-200.0 °C to 200.0°C
- 60.0°C to 200.0°C
0.1°C
0.5% L ±2°C
low
-328.0°F to 392.0°F
-76.0°F to 392.0°F
0.1°F
0.5% L ±4°F
-200°C to 1200°C
-60°C to 1200°C
1°C
0.5% L ±2°C
high
-328°F to 2192°F
-76°F to 2192°F
1°F
0.5% L ±4°F
The stated accuracy in temperature measurement does not take into account the
accuracy of the K thermocouple.
There is no upper limit on the temperature display, other than the 6000 D of the
display unit.
PEAK+ PEAK-
Add 1%L + 30D to obtain the accuracy corresponding to the function and the range.
Fmax = 1kHz (1ms)
MAX / MIN
Add 0.2%L + 2D to obtain the accuracy corresponding to the function and the range.
Acquisition time of the extrema: approximately 100ms.
Operation
of the audible beep
Beep reporting a valid key
Æ
high-pitched sound
4kHz, 100ms
Beep reporting an invalid key
Æ
low-pitched sound
1kHz, 100ms
Bursts of 3 beeps separated by 5-second gaps (beep beep beep - gap - beep
beep beep) reporting an overshoot of the danger threshold (600V)
Æ
medium-
pitched sound
2kHz, 100ms
2 successive beeps (beep beep) reporting recording of the MAX, MIN, PEAK:
Æ
medium-pitched sound
2kHz, 100ms
Current >10A
4kHz, 100ms
