Chapter II
30
Benchtop multimeter
2.4. Power
supply
The multimeter is powered directly from the mains either 110 V or 230 V, 50 Hz or 60 Hz.
The mains plug is located at the rear panel of the instrument.
2.5.
Measurement input terminals
Measurements are performed using two measuring leads supplied with the instrument
connected to input terminals 1, 2, 3 and 4, as indicated in § 3.1.
2.6.
RS 232 connector
A serial link - galvanic isolated - enables :
- the multimeter configuration (with SX-ASYC II software)
- the reading - and the printing - of the measured datas
- the re-calibration of the multimeter without removing parts.
The 25 points sub-D connector is located at the rear panel of the instrument.
2.7. Tilt
stand
- Push both latching devices as indicated by the arrows.
- Adjust the handle to position to the required angle.
- Release the latches.
→
←
T x D
R x D
GND
• • • • • • • • • • • • •
• • • • • • • • • • • •