5.1 Basic software operation
■■■■■■■■■■■■■■■■■■■■■■
30
■■■■■■■■
NOTICE
The
Result unit
depends on the unit of the standard solution. If
the concentration of the standard solution is a mass concentra-
tion, e.g. mg/L, also the result unit has to be a mass concentration,
e.g. µg/L. If the concentration of the standard solution is a molar
concentration, e.g. µmol/L, the result unit has to be a molar con-
centration too, e.g. nmol/L.
3
Close the dialog window
Method parameters
with
[OK]
.
The determination will automatically be recalculated and displayed
with the new result unit.
Excluding a curve from the evaluation
1
On the workplace go to the subwindow
Results
and select the tab
with the name of the substance for which a curve should be
excluded from the evaluation.
2
In the column
Used
deactivate the check box of the curve which
should be excluded from the evaluation.
3
Click on or
Menu bar
▶
File
▶
Reprocess
to reprocess the eval-
uation and calculation without the excluded curve.
Adapting the baseline parameters for all curves
1
Click on or
Menu bar
▶
Method
▶
Edit method parame-
ters…
.
2
In the dialog window
Method parameters
go to the tab
Evalua-
tion
, section
Substances
.
To set manual base points, deactivate the check box
Base points
automatically
and type in values for
Start base point
and/or
End
base point
.
A different baseline type can be selected from the drop-down menu
Baseline type
.
3
Close the dialog window
Method parameters
with
[OK]
.
Summary of Contents for 2.946.0010
