6
Figure 3
I
NSTALLING THE
S
CANNER TO THE
H
OST
S
YSTEM
Keyboard Wedge (MS9524-47 and MS9544-47)
1. Turn off the PC.
2. Connect the 10-pin RJ45 male
connector into the jack on the
Voyager
. You will hear a ‘click’
when the connection is made.
3. Connect the L-shaped plug of the
power supply into the power jack on
the PowerLink cable.
4. Make sure the AC input
requirements of the power supply
match the AC outlet. Connect the
power supply into an AC outlet.
The outlet should be near the
equipment and easily accessible.
5. Disconnect the keyboard from the PC.
6. Connect the PowerLink cable to the
keyboard and the PC’s keyboard
port. If necessary use the supplied
adapter cable (5-pin male DIN to
6-pin female DIN adapter).
7. Power up the PC.
Plugging the scanner into a port on the host system does not guarantee
that scanned information will be communicated properly to the host
system. Please refer to the MetroSelect Single-Line Configuration Guide
or MetroSet2’s help files for instructions on changing the scanner’s
factory default configuration. The scanner and host system must use the
same communication protocols.
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must
meet the requirements for SELV (Safety Extra Low Voltage) according to EN/IEC 60950-1.
To maintain compliance with standard CSA-C22.2 No. 60950-1/UL 60950-1 and norm EN/IEC
60950-1, the power source should meet applicable performance requirements for a limited
power source.
