17
I
NDICATORS
Audible
When the Voyager
is in
operation, it provides audible feedback. These
sounds indicate the status of the scanner
.
Eight settings are available for the
tone of the beep (normal, 6 alternate tones and no tone). To change the tone,
refer to MetroSelect Single-Line Guide,
MLPN
00-02544 or MetroSet2’s help files.
One Beep
When the
scanner
first
receives power, the blue LED will turn on,
then the white LED will flash and the scanner will beep once.
The white LED will remain on for the duration of the beep.
The scanner is ready to scan.
When the scanner
successfully
reads a bar code, the white LED
will flash and the scanner beeps once (if configured to do so).
If the scanner does not beep once and the white light does not
flash, then the bar code has
not
been successfully read.
Razzberry Tone
This tone is a failure indicator.
Refer to Failure Modes on page 19.
Three Beeps - During Operation
When entering configuration mode, the white LED will flash while
the scanner simultaneously beeps three times. The white and blue
LEDs will continue to flash while in this mode. Upon exiting
configuration mode, the scanner will beep three times, and the
LEDs will stop flashing.
When configured, 3 beeps can also indicate a communications
timeout during normal scanning mode.
When using one-code-configuration, the scanner will beep three
times (the current selected tone), followed by a short pause then
by a high tone and a low tone. This tells the user that the single
configuration bar code has successfully configured the scanner.
Three Beeps - On
Power Up
This is a failure indicator. Refer to Failure Modes on page 19.
