4
Figure 1
I
NSTALLING THE
S
CANNER TO THE
H
OST
S
YSTEM
RS232, Laser Emulation, and Light Pen
(MS9524-14/00/41 or MS9544-14/00/41)
1. Turn off the host system.
2. Connect the 10-pin RJ45 male
connector into the jack on the
Voyager
. You will hear a ‘click’
when the connection is made.
3. Connect the L-shaped plug of the
power supply into the power jack
on the PowerLink cable.
4. Make sure the AC input
requirements of the power supply
match the AC outlet. Connect the
power supply into an AC outlet.
The outlet should be near the
equipment and easily accessible.
5. Connect the PowerLink cable to the
proper port on the host system.
6. Turn on the host system.
Plugging the scanner into a port on the host system does not guarantee
that scanned information will be communicated properly to the host
system. Please refer to the MetroSelect Single-Line Configuration Guide
or MetroSet2’s help files for instructions on changing the scanner’s
factory default configuration. The scanner and host system must use the
same communication protocols.
All MS9524-00/MS9544-00 scanners leave the factory with the Laser
Emulation Mode enabled. If you recall defaults while re-configuring the
scanner the Laser Emulation Mode will no longer be enabled. Refer to
the
MS9520/9540-00 Laser Emulation Mode
section of the MetroSelect
Single-Line Configuration Guide for information on enabling the
Laser
Emulation Mode
.
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must
meet the requirements for SELV (Safety Extra Low Voltage) according to EN/IEC 60950-1.
To maintain compliance with standard CSA-C22.2 No. 60950-1/UL 60950-1 and norm EN/IEC
60950-1, the power source should meet applicable performance requirements for a limited
power source.
