3
7 - Push on the « « button of the transmitter, the red light
turns on.
8 - Switch on your main TV and then switch on all the sources
connected to the transmitter. Put your TV in A/V mode to view
the signal from the default source. Usually, this is done by
pressing the 0/AV key, or EXT, or AUX,… In case of problem,
please refer to the user manual of your TV.
9 - By pressing each one of the 4 bottom buttons (PRI) of the
provided remote control, check that you can see any of the
connected sources.
5
6 - Put the channel selection switch on position «1»
Setting up receiver
B
10 - Link the receiver and the secondary TV with the provided
scart lead
11 - Switch on the SEC TV and put it in AV mode. The screen
should be black
12 - Plug the AC/DC adapter on mains and connect it to the
receiver.
13 - Put the channel selection switch on position «1»
14 - Press the « « button on the receiver, the red light should
turn on and the programme from the transmitter should
appear on the secondary TV. If not, make sure that all the
sources from the main TV are on, as well as the transmitter.
15 - By pressing each one of the 4-buttons remote control, check
that you can select any source from the distant room. If the
picture is not OK, try to move the receiver to a better location
(a few inches may sometimes do the trick). In case of no
other location is found suitable, try another channel on BOTH
transmitter AND receiver.
0 208 994 11 81
