3
8
0 208 994 11 81
HOW TO USE
5
To watch a source (DVD, SAT, VCR) on the main TV, switch on the
main TV and force the AV mode, the screen should be black. Switch
on the source in question on and press the relevant key on the 8-but-
tons (PRI) remote control. The picture and sound are now available
on the main TV, and the related LED lights red. If itʼs orange, it means
that source is also sent to the receiver. If you donʼt have the remote
control to the hand (or in case of the batteries are worn-out), you can
use the buttons located on the transmitter. Press the PRI/SEC button
until it lights red and press the button for the source.
To watch a source (DVD, SAT, VCR) on the secondary TV, switch on
the source and the secondary TV. The main TV may remain off. Force
the AV mode on the secondary TV and select the source with the 4-
buttons remote control. The picture and sound are now available on
the secondary TV. On the transmitter, the related LED lights green. If
itʼs orange, it means this source is also sent to the main TV.
• The screen of the
secondary TV shows
only snow.
• The screen of destination
TV stays black (or blue).
• The remote extender
doesnʼt work.
• The transmission seems
not to work.
TROUBLE SHOOTING
6
•Put the TV in AV mode (key EXT, 0/AV, AUX,).
• Check that the transmitter is ON
• In case of multi scart TV, check that you
selected the right AV input.
• Check the position of the infrared mouse
• List all other wireless appliances and
disconnect them.
• The transmission range of remote extender
is a little bit shorter than the range for the
video. Check if itʼs better when you move the
receiver closer to the transmitter
• Try and change the channel, be sure that
the channel on receiver is the same as the
channel on transmitter.
