DL2
15
4.5 IN6TC - six channel mV type input module
inputs dedicated for temperature measurements with thermocouples (see technical data
for complete list of sensor types),
compensation of cold junction with a fixed value or a measurement using another
channel,
linear measurement of the voltage within the range or sub-range -140 .. +140 mV,
galvanic separation from the remaining device circuits, no separation among the input
channels,
each input has a separate four-pole plug-in terminal block,
two colour LED diode informing about the module's operating status.
4.6 IN6V
– six channel voltage type input module
standard voltage type inputs: 0-10V, 2-10V, 0-5V, and 1-5V,
linear measurement of the voltage within the range or sub-range -10 .. +10 V,
galvanic separation from the remaining device circuits, no separation among the input
channels,
each input has a separate four-pole plug-in terminal block,
two colour LED diode informing about the module's operating status.
4.7 IN3
– three channel universal type input module
software configurable input type:
current loop 0/4-20mA (active transducers),
temperature measurements using the Pt, Ni, Cu, KTY type sensors,
temperature measurements using thermocouples,
voltage type inputs 0 .. 10 V, -10 .. +10 V,
linear current measurement within the range or sub-range of -20 .. +20 mA,
linear measurement of the resistance within the range or sub-
range 0 .. 4000 Ω,
linear measurement of the voltage within the range or sub-range -140 .. +140 mV,
-10 .. +10 V,
galvanic separation from the remaining device circuits, no separation among the input
channels,
each input has a separate four-pole plug-in terminal block,
two colour LED diode informing about the module's operating status.
4.8 IN6D
– six channel binary inputs module
dedicated to measure frequency, pulse counting or state tracking,
frequency range of 0.1 .. 1000 Hz (pulse counting in range 0 .. 100 Hz),
0 .. 4 VDC / 5.5 .. 34 VDC (3.6 mA) according to EN61131-2 characteristics),
other switching current level at 0.45mA, 1.55mA or 2.44mA can be selected with
jumpers located on the module PCB,
accepts passive pulse transmitter (contact or transistor configuration OC), the source
voltage or current pulses,
galvanic separation from the remaining device circuits, no separation among the input
channels,
each input has a separate three-pole plug-in terminal block,
each input has a LED diode to indicate the input state level,
two colour LED diode informing about the module's operating status.
Summary of Contents for DL2
Page 47: ...DL2 47 Notes ...
Page 48: ...DL2 48 Notes ...
