7
technical support: soporte@metronic.com
EN
We recommend that the batteries of the two controls may be loaded as possible.
1 - Press and hold the button for the device you want to copy (ex.: TV) while the
«Learn» button. When the red LED lights, command and will depend learning (in this
case to control TV).
2 - Press and release the button universal remote we want to record (ex.: POWER),
the LED flashes (if no button is pressed within 14 seconds, the remote will exit the
learning mode automatically).
3 - Press a button on the remote copy (ex.: POWER) once the LED flashes 3 times
faster then stops blinking maintaining the steady light, it means you have accepted
the new code for that button and you can start record another command button (if no
button is pressed in 14 seconds the controller will automatically learning function, and
will need to start from step 1).
4 - Repeat steps 2 to 4 for learning from other codes from the original remote.
5 - When all buttons you wish to copy, press the «Learn» button to record and save
changes to the universal command and exit the function completes learning.
6 - Press TV + 6 button and wait until the LED blinks three times. This will erase all
codes that you have learned from all devices.
Note:
Orient the original remote infrared transmitter to the receiver looking infrared universal
remote leaving about 30 mm. Keep the two knobs on the same line to make the
process of learning as reliable as possible.
5 - Set up by learning function
Simply press the TV button and numeric 3 together for 3 seconds, all settings will be
deleted, and the remote goes back to factory default settings, the LED will flash two
times once it’s successful
Remote does not operate your product
Press the device button of the product
you want to control
Program the remote with a new code
from code list
Remote may not be compatible with
your product, please set up by learning
function
6 - Reset / Delete Function
Troubleshooting
