METRONIC RF command is equipped with a gyroscope to move the pointer
simply by directing the command to the screen. For example, if you move
slightly the front end of the knob up, the screen pointer will move up, and so in
all directions. The control functions as well as mouse on a computer.
Installation:
- Open the battery compartment and then insert 1 battery 3V CR2032 mat-
ching the polarity.
- Connect the USB receiver into a free port of your IP box, Android tablet
or computer.
- When the IP box, Android or Tablet computer is on, press the mouse button
(see below) to activate the cursor.
Note: for a connection Android Tablet or Smartphone, an adapter cable is
required OTG (On-The-Go).
RCU description
Pairing
•
Press
OK
and
BACK
buttons together, hold for 3 seconds and release,
press the buttons to check if they can work well.
•
If pairing failed, RC will enter sleep model after 25 seconds without
operation.
MOUSE function
•
The default status for air mouse is OFF, press button to turn on/off air
mouse.
•
RC will enter low power consumption status if no operation within 20
seconds.
•
If the arrowhead was found drift on the screen, leave it on the horizontal
surface for 3 seconds to adjust automatically.
Note: The operation of some function keys may depend on their availability
in the operating system in which the controller is connected
Technical specs:
- 2.4GHz (2404MHz – 2479MHz) / 10mW
- GFSK modulation
- Power : CR2032 battery (not included)
In the case of inactivity for a long time, remove the batteries and store the
USB receiver.
EN | REMOTE CONTROL UNIT WITH RF
MOUSE key:
To turn on / off the mouse
function.
Hold this key to move the
pointer
