5-4 Utilization:
Your Power Supply for Kalista CD transport is adjusted for a nominal voltage
corresponding to your country's electrical network.
If it fails to operate:
A - Turn off the Kalista CD Transport.
B - Unplug all the cords.
C - Replug the cords.
D - If there is no difference, please contact Metronome Technologie factory.
The LED on the front panel indicates the state of the unit: when the LED is alight, the
power supply is operational.
This power supply can be switched on during a long period however for a prolonged
absence, we advise you to switch it off, with the switch on the rear panel of the machine.
This power supply is protected by internal electronic circuits and by a general fuse
situated in the block near the main chord, beside the switch. To change the fuse, it is
imperative to unplug first the main cable, then open the fuse compartment (see photo on
paragraph 5-3) with a screwdriver and replace the fuse by an identical model: 1 Ampere slow
blow. The machine is delivered with a second fuse.
ATTENTION: Never modify the value of the fuse.
Note: it is possible that after a long period without functioning, the fuse burns out when
the power supply is switched on: in fact when the power supply is completely discharged, on
switch on, there is a very important current consumption during a brief instant.
