DRIVING INSTRUCTIONS
DRIVING INSTRUCTIONS
D100014616-EN
398 0 EN 2021-06-22
13
Callout
Description
1
Adjustment sleeves
2
Locking pins and clips
3
Screen angle trestle
4
Screen UP-DOWN
Figure 16: Raising the screen angle
2. Remove the screen box angle adjusting clips and locking pins (2) from the adjustment sleeves (1).
3. Using the Screen UP-DOWN control (4), raise the screen angle by moving the screen angle control to
the RAISE position.
4. Raise the screen angle trestle (3) slightly above the desired operating position.
5. Move the adjustment sleeves (1) to the desired hole and replace the locking pins and clips (2) in the
screen angle trestle (3).
NOTICE: Make sure that both trestles are adjusted equally, failure to do so will damage the
screen box assembly.
6. Using the Screen UP-DOWN control (4), lower the screen angle trestle (3) by moving the Screen UP-
DOWN control (4) to the LOWER position. Lower the screen angle trestle (3) so that it rests securely
on the adjustment sleeves (1) and locking pins (2).
7. Turn all hand rails to operating position (up) and lock.
A
B
Figure 17: Hand rails to operating position (up) and locking
A: Turn the handrail up and attach the locking pin.
B: Attach the other locking pins (3 pcs).
8. Turn the switch for manual valves to OFF position. Otherwise, track driving is not possible.
