IMO 3/20
8
IMO-502 EN
3. Apply drop of 7649 primer (dryer) on internal threads of
piston rod. Wait for a minute and again apply a drop of
242 loctite on same threads. Now tighten the piston rod
(5) with the help of SHC screw (8) by using washer (13).
4. Insert this piston rod assembly carefully into the tube (3).
8.3
Front cover assembly
1. Clean it with liquid soap solution. After drying apply
RMEBS grease rubber parts.
2. Place rod seal (14) on its groove.
3. Place Cushioning seal (15) and o-ring (17) on its groove.
Place o-ring (19) on cushioning screw (12), assemble
the cushioning screw on rear cover (2).
4. Assembled the front cover (1) on the tube (3), fasten the
cylinder cover nut (9) and engage the lock nut (7).
NOTE: Operate the cylinder assembly by hand. It should be
free rotating piston rod & operating in and out.
Summary of Contents for JAMESBURY CC Series
Page 11: ...IMO 3 20 IMO 502 EN 11 ...
