www.mettatec.com
Image: Camera Control screen with trigger event time detected by the sensor.
4.
Now the M2 / M + module is ready to operate.
Topographic Survey Flights
Before Flight:
1.
Program your flight plan following the instructions of the flight control application
you use: DJI GS Pro, Pix4D, DroneDeploy, MapsMadeEasy or others.
2.
Connect the previously installed PPK KIT by connecting the Micro-USB cable to the
Drone.
3.
Turn on the Drone Phantom 4 Pro / Advance.
4.
Wait for the three lights on the M2 / M + to come on: Orange, Blue and Green. It
takes about 30 seconds to wait for the Blue (Wifi) and Green (Satellites) lights.
5.
In the event that at the first start of the Drone the M2 / M + module does not turn
on completely (only orange light on) do the following: disconnect and reconnect
the 6-pin connector directly from the M2 / M + module without turning off the
Drone. This happens due to slight variations in power performance in some Drone
batteries due to time of use (low amperage) or other factors external to the kit.
6.
Connect to the M2 / M + via Wi-Fi
(See point 6 of the section: M2 / M + module
configuration: Reachview 3 App and Firmware update)
.
