2.4.2 Selecting and setting the
special functions
Additional special functions can be selected in each flash
mode with the
Select
button.
By depressing the
Select
button you can call the special
functions "Bleep" , automatic switch-off (clock sym-
bol), REAR
3)
(second-curtain synchronisation), modelling
light
, zoom formats and flash bracketing "Fb".
3)
only with SCA adapter and camera which support this function.
The icon of the given function flashes after the special
function has been set, and the functional status (OFF or
ON) is shown on the LC display.
The selected function is switched on or off by turning the
setting disk.
The set function is stored by pressing the setting disk.
Note: The individual flash modes are explained in a
separate chapter!
2.4.3 Setting ISO / Zoom / Aperture
, „P“ Par-
tial Light Output and EV (flash exposure
correction)
Turn the setting disk to select the required function (ISO /
Zoom / Flash Exposure Correction „EV“) on the right-
hand side of the LC display. The selected function is indi-
cated by an arrow
ŀ
.
Push the setting disk in the direction of the arrow to
change the function. The arrow
ŀ
on the LC display will
flash. Change the status by turning the setting disk. To
store press the setting disk in the direction of the arrow.
The selected setting will be automatically stored after
approx. 5 seconds if the setting disk is not pressed. The
arrow at the selected position will stop flashing after sto-
rage.
When operating the mecablitz with an SCA 3xx2
adapter it may not be possible to change the
f–stop (depending on the camera type and SCA
adapter)!
When operating the mecablitz with an SCA 3xx2
adapter it may not be possible to change the ISO
film speed, or the ISO film speed may not be dis-
played (depending on the camera type and SCA
adapter)!
Note: The individual settings are explained in a separate
chapter!
☞
16
Operating concept
Filosofia di azionamento
Filosofía de manejo
700 47 0078-A4 PDF GB-I-E 30.09.2008 14:12 Uhr Seite 16
