15
3.5 Carry out complete code search
• Switch on your external AV device.
• Press the
or
or
button to be programmed
(about five seconds), until the upper button row briefly flashes
twice.
• Within ten seconds enter the four-digit code "0001" to activate the
search.
To confirm that the search has been activated, the upper button
row briefly flashes twice.
• Press and hold the
button of this remote control until the
external AV device switches off. If the external AV device switches
off during the search, immediately release the
button and
press the
button. The setting thus found is saved.
The button flashes twice.
If the external AV device switches off, a matching code has been
programmed.
The complete code search can take up to ten minutes.
AUX
STB
DVD
3.6 Delete programming of a button (RESET)
• Press the
or
or
button to be programmed
(about five seconds), until the upper button row briefly flashes
twice.
• Enter the four-digit code "0000" within ten seconds.
• The button to be programmed acknowledges the code entry by
flashing twice.
3.7 Programming the remote control with the device code for
different Metz TV sets with Ch. 613
• Turn on your Metz TV set.
• Press the
button to be programmed (about five seconds),
until the upper button row briefly flashes twice.
• Enter the four-digit device code (e.g. "1000") for your Metz TV set
within ten seconds.
• The button to be programmed acknowledges the code entry of an
existing code by flashing twice.
If
all
the
buttons , , , are
illuminated
for about two seconds, this indicates an error, or that the
entry was incomplete. Repeat the entry.
TV
TV
DVD
STB
AUX
AUX
STB
DVD
