CHAPTER 3: CONNECTING THE GALILEO 408
24
Connecting the SIM 3 Audio Analyzer
The Galileo 408 rear panel includes a bus for direct connection to the SIM 3 audio analyzer.
Once connected, the Galileo 408 can act as a line switcher for the analyzer and be used to
measure across any selection of inputs and outputs.
The default bus address for the Galileo 408 is 10 and the available range is 1–14. When the
SIM 3 is connected to the Galileo 408 it is auto-detected and its presence is indicated on the
front panel’s SIM 3 LED. The SIM 3 also appears in the Compass control software on the
Settings > SIM 3 page.
System Settings for Galileo with SIM 3 Software 1.7.x
SIM 3 analyzers with version 1.7.0 software and later allow for two probe points when using
the SIM 3 bus extension cable between Galileo and the SIM 3. In the Compass control soft-
ware on the Settings > SIM 3 page, you can set the Output Probe Point to either of the follow-
ing options:
■
Output Post Delay
, includes TruShaping EQ, Parametric EQ, SIM 3 Trim, Polarity, and
Delay.
■
Output Post Gain
, includes TruShaping EQ, Parametric EQ, SIM 3 Trim, Polarity, Delay,
Atmospheric Correction, Array Correction, and High/Low Pass and Gain.
Before you can measure Galileo inputs and outputs with the SIM 3, you must verify the
switcher configuration in the SIM 3 software (choose Settings > Switchers to open the
Switchers dialog box). Addresses 10–14 are reserved for Galileo. Next, connect the bus cable
between the two devices using the Line Switcher port on the SIM 3 rear panel. Three branch
combinations are available when measuring Galileo inputs and outputs.
Galileo 408 SIM 3 Bus Connectors
Summary of Contents for Galileo 408
