2
3
1
17
PUSH HANDLES
The height adjustable push handles are
about 150 mm continuously height adjus-
table and secured against being pulled out
[1].
Push handles with clamping
device
☞
In doing so, hold onto the push handle
that is to be adjusted with one hand.
☞
After each adjustment the clamping
lever is to be tightened sufficiently, so
that the push handle cannot be turned
anymore.
Height adjustment:
Loosen the clamping screw with the clam-
ping levers (2) so far that the respective
push handle can be adjusted into the desi-
red position.
Angle adjustment:
To change the position of the push hand-
les, loosen the clamping screw through the
clamping lever (2) and turn the push hand-
les into the desired position.
Extracting/inserting:
1. Press down the respective spring but-
ton (3) in order to extract or insert the
push handles.
2. Afterwards retighten the clamping
screw with the clamping levers (2).
Special features of the clamping
lever
The clamping lever (2) can be turned into
an operation position that is comfortable
for you.
For this pull the clamping lever (2) outward
(direction of the arrow), until the teething is
released.
After turning the clamping lever (2) let the
teething snap back into place.
Summary of Contents for 1.155
Page 1: ...en Operating manual W e m o v e p e o p l e Adaptive wheelchair Model 1 155...
Page 2: ...2...
Page 38: ...38 NOTES...
Page 39: ...39 NOTES...
