77
Electrical back support adjustment
4. Remove the seat cushion (fig. 51.9).
5. Pushing the arm supports outward.
Therefore observe chapter < Ad-
justing the seat width >.
6. Open the velcro fastener of the
spanning belt.
7. Lift off the battery cover (fig.
51.10).
8. Remove the wing nuts (A, fig.
51.10).
9. Pull out the safety wire (B, fig.
51.11).
10.Only then lift the plate with the
CAN-bus controller over the thread
pins (A, fig. 51.10) and adjust to the
front.
11.Afterwards swivel the plate with
the CAN-bus controller upward to
the front (fig. 51.12). Secure the
plate against unintentional swivel-
ling.
+
When swivelling the plate up pay
attention to the attachment of the
horn (fig. 51.8).
+
Continue with section < Battery
removal >.
51.10
51.11
51.12
51.9
A
B
A
