24
DRIVE WHEELS
The driving wheels can be removed
and reassembled without any tools.
No person may be seated in the
wheelchair during assembly or rem-
oval. The wheelchair must stand on a
level and firm surface. Before starting
the disassembly work, support the fra-
me to prevent the wheelchair from
tipping over and secure it to prevent
an unwanted movement or tipping
over.
Quick release axle
– Push in the stop button in the cen-
tre of the wheel hub (fig. 30/
➀
).
– Remove or attach drive wheel.
!
Attention:
After installing the drive wheel, the
stop button must protrude a few
millimeters from the wheel nut.
•
The drive wheel is then secured in
position.
☞
Note:
☞
The stop bolt must be kept clean.
A functional fault may occur in the
case of contamination due to sand
or earth or in the event of freezing
of moist cold air.
☞
Always carry out a tensile test af-
ter each assembly!
30
1
Summary of Contents for BRIX 1.123
Page 1: ...1 CHILDREN S WHEELCHAIRS BRIX Model 1 123 OPERATING MANUAL TheMotivation GB...
Page 2: ...2...
Page 40: ...40 NOTES...
Page 41: ...41 NOTES...
