11
GB
PUSH HANDLE
The insertion tubes (Fig.40) can be re-
placed with push handles (Fig.41).
Fitting push handles
Tools:
Hexagonal stud wrench WW* 4
Phillips screwdriver
– Pull the backrest belt off the Velcro
strips and wrap it forwards.
– Remove screw connection (A,
Fig.40).
– Remove the backrest strap.
– Remove screw connection (B,
Fig.40). – Keep hold of the insertion
tube as it will otherwise slide into the
backrest tube.
– Replace insertion tube with push han-
dle (or vice versa) and position it at
the desired hole location.
– Assemble screw connection (B,
Fig.41).
– Re-fit backrest strap.
– Assemble screw connection (A,
Fig.41).
– Re-fasten the backrest belt.
SEAT TILT
Only on model 2.874
The adjustment should be carried
out by the specialist dealer!
The seat tilt is infinitely variable by con-
stant chassis geometry.
Benefits:
– High sitting stability by way of
wedge-shaped seat position via ad-
justable seat tilt.
Handling:
Tools:
Hexagonal stud wrench WW* 4+5
Open-end spanner WW* 10
– Fold armrests onto the seat.
– Slacken the screw connection of the
rear seat-strut mount (A, Fig.45).
– Slacken the screws of the clamping
guides (B, Fig.44).
– Adjustment of seat tilt. – Position the
backrest tubes for the desired rear
seat-height.
+
Remark:
•
After adjusting the seat tilt, it is also
necessary to reposition the sides
(see section on Sides)
•
The adjustment should be made so
that the backrest tubes protruding
from the clamping guides have the
same length.
– Tighten the screws (B, Fig.38) of the
clamping guides.
– Tighten the screw connection of the
rear seat-strut mount (A, Fig.37).
WW* = Wrench width [mm]
