6
ARMRESTS
The choice of foldable or slide-action
side parts is dependent on the seat tilt:
Armrest code 302 (Fig.16) for up to 8
cm tilt and
armrest code 303 for seat tilt of more
than 7 cm.
A readjustment of the armrests for the
proper closing of the Velcro fastening
after a change in the seat tilt is recom-
mendable.
Handling:
Tools:
Phillips screwdriver
Open-end spanner WW* 8
– Fold side parts inwards (Fig.17).
– Slacken the adjustment screws (A,
Fig 17).
– Adapt armrest position. – Adjust the
side parts until the Velcro strips are
almost aligned.
– Tighten the adjusting screws (A, Fig.
17)
– Upright the side parts by folding them
outwards up to the end stop. – Side
parts will be held by the Velcro fas-
tener.
LEG RETAINER
The leg retainer code 316 (Fig.15) is
mounted by way of a clamp on the front
frame.
Benefits:
– Stabilisation of the leg position.
– Infinitely variable adaptation to the
personal needs of the user.
Handling:
Tools:
Hexagonal stud wrench WW*6
– Loosen adjustment screw (C, Fig.
15).
– Individually position the leg retainer
by rotating and/or sliding.
– Tighten adjustment screw.
Tools:
Hexagonal stud wrench WW*6
– Loosen adjustment screw (D, Fig.
15).
– Individually position the leg retainer
by rotating and/or sliding.
– Tighten adjustment screw.
WW* = Wrench width [mm]
RAM BAR
PROFI 3-T, model 2.874
The ram bar (Fig. 11) is removable.
Remove ram bar
– Slacken the adjustment screw (A,
Fig.12) of the tube clamp.
– Slacken the fastening screws (B, Fig.
13)
– Remove ram bar by pulling forward
(Fig. 14).
Mount ram bar
– Place the ends of the ram bar tubes
into the pipe clips (Fig. 11).
– Tighten fastening screws (B, Fig. 13)
– Tighten the adjustment screw (A,
Fig.12) of the tube clamp.
