6
LEGRESTS
Handling:
– Operate parking brakes. – This pre-
vents the wheelchair from rolling
away accidentally.
– Remove lower leg strap [7], if
present.
– Remove both feet from the foot
plates
– Fold up foot plates [8] (Fig.9).
– Press the locking lever (A, Fig.10)
outwards and
– Turn legrest [5] to the side (Fig.11).
!
Attention:
Danger of squashing during swivel-
ling out of legrests!
Taking off the legrests
(model 3.310 only)
Benefits:
– Easy transfer into and out of the
wheelchair.
– Foot and side areas are free, no
stumbling
– “shuffling” possible (moving the
wheelchair forward with the feet).
– Reduced length of the wheelchair -
important for storing wheelchair
Handling:
– Operate parking brakes. – This pre-
vents the wheelchair from rolling
away accidentally.
– Remove lower leg strap [7], if
present.
– Remove both feet from the foot
plates
– Fold up foot plates [8] (Fig.9).
– Press the locking lever (A, Fig.10)
outwards. – Legrests have now been
released.
– Turn legrest [5] to the side slightly
and pull up and off (Fig.12).
Attaching the legrests
Handling:
– Insert the hinge pins of legrest (5) into
their sleeves from the top (Fig.12)
and then swivel the legrest inwards.
– Check correct hinge pin insertion and
locking of the legrest!
!
Attention:
Both hinge pins of each legrest must
be inserted into their sleeves.
The locking of the legrest must audi-
bly click when swivelling inwards af-
ter legrest attachment.
Adjusting the length of the
legrests
The legrest length is infinitely adjustable
by 12 cm by way of a non-rotating tele-
scopic tube.
Benefits:
– Individual adjustment of the legrest to
the length of your lower leg
Handling:
Tools:
Hexagonal stud wrench WW* 4
– Operate parking brakes. – This pre-
vents accidental rolling of the wheel-
chair (see section “Parking brakes”).
– Slacken the adjustment screws (A,
Fig 13).
– Push telescopic legrest (5) to re-
quired length.
– Do not forget to
tighten the adjusting screws again.
+
Remark:
–
Observe the 7 cm minimum inser-
tion depth of the telescopic tube!
–
Avoid a strong pressure between
thighs and safety belt edge. –
Blood circulation problems!
WW* = Wrench width [mm]
Depth adjustable foot plates/
boards
Benefits:
– You can set the angle between the
tight and lower leg to your most com-
fortable position.
Handling:
Tools Hexagonal stud wrench WW* 5
– Operate parking brakes. – This pre-
vents accidental rolling of the wheel-
chair (see section “Parking brakes”).
– Remove feet from the foot plates/
board (8).
– Screw out the cheese head screws
on the foot plates/board.
– Move the foot plates/board to the
desired position and then screw in
the cheese head screws.
