39
38
Height-adjustable legrests
(Option)
(Fig. 53)
Removal
Pull up the locking device (fig. 54/
➀
).
Swivel out the legrest and then pull it
off in an upward direction.
Fitting of
With the legrest in the swivelled-aside
position, hang it in and then swivel it
to the front until the locking device
audibly latches. - Check for a correct
locking of the locking device!
Adjusting the height of the
foot plate
Slacken the clamping screw (fig. 55/
➁
) to adjust the height of the foot
plate.
Telescope the foot plate to the desired
height and then tighten the clamping
screw.
!
Attention:
The marking (hole) shows the max-
imum extension.
53
1
54
2
55
1
Remove the legrests
Undo the calf strap at one side before
removing the legrests.
Pull up the locking device (fig. 50/
➀
)
swivel out the legrest and then pull it
off in an upward direction (fig. 51).
Attaching the legrests
With the legrest in a swivelled-aside
position, hang it in and then swivel it
to the front until the locking device
audibly latches. – Check that it is se-
cure! Attach the calf strap.
Adjusting the height of the
foot plate
Tools:
1 x open-end or ring spanner WW* 10
Remove the clamping screw (fig. 52/
➁
) to adjust the height.
Telescope the foot plate to the desired
height and then secure it with the
clamping screw.
*WW = Wrench width (mm)
51
52
50
2
![Dietz AS[01] Operating Instructions Manual preview](http://thumbs.mh-extra.com/thumbs/dietz/as-01/as-01_operating-instructions-manual_2495921-01.webp)
