43
42
Strapping on the lap belt with
lock
▲
Pull both belt halves to the front
and slide the catch halves together
so that they latch together (fig. 52).
Then carry out a pull test.
You open the lap seatbelt by pressing
in the red unlocking button (fig. 60/
➀
).
Adjustment of belt length
☞
Note:
The lap seatbelt should not be too
tight.
By shifting the catch (fig. 60/
➁
) and /
or pulling on the end of the belt (fig.
60/
➂
) the length of the lap belt can
be changed.
Putting on the lap seatbelt with
velcro fastener
▲
Lay the two ends of the belt on top
of each other at the desired length
and press them together. Then car-
ry out a pull test.
!
Attention:
Make sure that no objects are
trapped between belt and the
body! – Thus you avoid painful
pressure points.
60
2
1
3
OPTIONS
Options are not a part of the standard
scope of supply.
☞
Note:
Options from other companies can
cause malfunctions.
LAP BELT
The lap belt is used for securing a per-
son sitting in the wheelchair.
– Additional stabilization of the sit-
ting position.
– Prevents the user from falling for-
wards out of the wheelchair.
– Continuous adjustment to suit the
user’s needs.
The lap belt is screwed on, from the
outer side, at the respective backrest
holder (fig. 59).
59
☞
Note:
The retrofit of a lap seatbelt may
only be carried out by an author-
ised dealer!
!
Attention:
The lap belt is not a part of the se-
curing system for the wheelchair,
or the person sitting in the wheel-
chair, during the transport in a dis-
abled person transport vehicle.
