30
TECHNICAL DATA
All data in the following tables refer to
the standard model version.
Dimensional tolerance is ± 1.5 cm.
Overload limiting
40A min. for 15 sec. min.
Blade-type fuses
•
60A main fuse (6 km/h)
•
60A main fuse (10 km/h)
•
20A charging fuse
•
2A
power electronics control
•
7,5A electrical adjustments
•
5A
lighting
•
5A
steering
Filament bulbs
Headlights:
Ball lamp
24V/3W E10
Back light:
Festoon bulb
24V/C5W S8,5
Front indicator:
Ball lamp
24V/10W BA15s
Rear indicator:
Ball lamp
24V/21W BA15s
FAULT INDICATIONS ON THE
LCD DISPLAY
An error code appears or the signalling
bar flashes on the LCD display if there is
a malfunction.
The error codes help the specialist work-
shop to quickly identify the cause of the
malfunction.
The electronics performs a self-test after
the control box has been switched on.
The signalling bar blinks until this self-test
has been completed.
Do not move the joystick out of the zero
position during the self-test. – If you do,
switch off the wheelchair and then switch
on again and wait until the signalling bar
stops blinking.
Indication and effect
E 54, E 55
Warning E 54,
the wheelchair standstill E 55
Cause
Low battery voltage due to fully dis-
charged batteries.
Remedy
Recharge batteries immediately.
Recharge batteries!
Contact your authorised dealer in the
event of other error indications.
SERVICE
