CD-3706/P
Operator’s
Guide
Document Revision: 030501.1
5000 Series
Operator’s Guide
Document Revision:080504
Page 27
Copying From A Hard Disk Image
After a hard disk image has been created, it can be used as the copying master
source. If you have not already created a hard disk image, do so now, as described
in the previous section.
Multiple Images Disabled
To make copies from a hard disk image that was previously created with
the
Multiple Images
feature “disabled” (i.e. from a single hard disk image),
the steps are as follows:
•
From the main operating screen depicted below:
•
Load as many blank discs as are required into the CD-R/RW recorders.
•
Press the “COPY” key on the keypad. The screen will now read:
•
Press the “START/YES” key to begin copying from the hard disk
image, to the blank discs in the recorders. Depending on the format type
of the image, something similar to the following will be displayed on
the screen:
Progress will be displayed on the screen during the operation:
