1. Turn off the power Remove the power cord
and USB Cord from behind Baxter.
2. Carefully, place Baxter on its side (label
side).
3. On the bottom on the arm assembly there
are two phillips screws on the silver
bracket. Remove the two phillips screws.
4. The arm assembly has a hook and a slip
notch that attaches to the drive base. You
will need to push gently in an upwards
motion to detach the arm assembly.
5. Upon doing this, you will see a yellow
ribbon cable. The cable is attached to a pin
connection on the side of the drive base. It
might be easier to disconnect it temporarily
while performing the next few steps.
How to reset Baxter’s Arm if it gets stuck.
