Page 13
Director EC Office Publisher
with OptiEC PRO Printer
Installation Guide
Document Revision: 12/28/2004
Aligning the OptiEC PRO Printer
(fig. 3)
(fig. 4)
(fig. 5)
Alert:
Before starting the Alignment Utility,
position the back end of the inkjet printer
in line with the dotted line on the top of
the drive bay.
1.
From the Start Menu Open the
SCRIBE EC
Alignment Utility
. It will be located in the
folder designated when you installed the
alignment utility. Choose the appropriate COM
Port Number, which the Scribe EC Loader is
connected to then choose the
OptiEC
then
Click the
Start Test
button
(fig. 1)
.
2. Follow the onscreen instructions then Click
Yes
button
(fig. 2)
. The picker arm will then
hover a disc over the open printer tray.
Observe disc’s position and make the
appropriate adjustments to the printer
(fig. 3)
.
3. Click
Yes
when you are satisfied with your
adjustment
(fig. 4)
.
4. The picker arm will then place a disc onto the
printer tray. Follow the on screen instructions
then click the
OK
button
(fig. 5)
.
5. Once you are satisfied with the printer’s
alignment, tighten the thumbscrews located on
both
side of the printer
(fig. 6)
.
(fig. 1)
(fig. 6)
(fig. 2)
