32
RM X In
/
RM Y In
– these two input jacks allow one or two
external signals to be fed into the analogue ring
modulator. A signal being fed to
RM X In
replaces the
signal of
VCO1
, while a signal being fed to
RM Y In
replaces the signal of
VCO2
. Both signals can be
controlled in level using the
VCO1
and
RM Y
controls in
the
Mixer
section.
LFO1 Out
/
LFO2 Out
– these jacks carry the waveform
outputs of both LFOs for a possible modulation of
external targets.
LFO2 In
- this input jack allows modulation of
LFO2
's speed
using an analogue control voltage.
ADSR1 Out
/
ADSR2 Out
/
AD Out
- these jacks carry the
signals of all three envelopes for a possible modulation of
external targets.
Rib1 Out
/
Rib2 Out
- these jacks carry the signals of both
ribbon controllers for a possible modulation of external
targets.
Master
– this jack outputs the same signal as the
Audio
OUT
jack on the rear panel. This output may serve for a
connection to Eurorack modules.
Summary of Contents for DOMINION 1
Page 1: ...Operating Manual...
