MFJ-4726RC 6–Position Antenna/Transceiver Switch Remote Control
2
INSTALLATION
1. See the MFJ-4726 Instruction manual for complete
instructions.
2. The unit can be located at any convenient location, as
long as it is not exposed to moisture. It should be
grounded to the station ground, and preferably
powered from a separate wall adaptor.
3. Connect your antennas to the SO-239 coax
connectors numbered 1-6. Note which antenna is
connected to each connector.
4. Connect your transceivers to the SO-239 coax
connectors labeled A-F. Note which transceiver is
connected to each connector.
5. Connect a feedline from the TRANSMITTER
COMMON connector to the ANTENNA COMMON
connector.
6. Connect the station ground to the GROUND
connector.
7. When using the MFJ-4726RC Remote Control,
connect a RJ-45 modular jack from the remote control
to the ANTENNA REMOTE jack on the back of the
unit and connect a RJ-45 modular jack from the
remote control to the TRANSMITTER REMOTE jack
on the back of the unit using a CAT-5 cable.
6. If your Transceiver is equipped with a Radio Sense
jack, you may connect it to the Remote Control using
a RCA plug so when your Transceiver is off, all inputs
are automatically grounded.
