VEC-821KC Assembly Manual
Super CW Filter
4
!
!
6. Install the 1/4" mono phone jack (11) as follows:
a
). Slip the flat steel
washer (15) over the threaded end of the jack.
b
). Install the threaded
end of the jack from the inside of the chassis, through the front panel
hole.
c
). Position the jack as shown in the Parts Placement diagram.
d
). Secure the jack to the front panel using the 9MM hex nut (12).
!
!
7. Install the screw-type terminal board (10) into the horizontal slot on
the rear panel using two 4-40 x 3/16" machine screws (1) and two (2)
4-40 hex nuts (3). Install the terminal board from the inside of the
chassis. The solder lugs should be up and away from U2.
Wiring the Enclosure
You must position the enclosure so the front panel is facing you. For the
following point-to-point wiring steps you will also require the VEC-821K
manual to locate some of the reference points mentioned.
!
!
1. Connect the insulated wire, located to the point on the circuit board
labeled
INPUT
, to the right solder lug on the terminal strip. Solder in
place.
!
!
2. Connect the insulated wire, located at
GND2
on the circuit board, to
the left solder lug on the terminal strip. Solder in place.
!
!
3. Connect the insulated wire, located at
GND3
on the circuit board, to
the short lug on the ¼" phone jack. Solder in place.
!
!
4. Connect the insulated wire, located at
SPKR
on the circuit board, to
the long lug on the ¼" phone jack. Solder in place.
!
!
5. Locate the piece of double-sided tape. This is to be used for holding
the 9-volt battery clip in place. Locate a place on the underside of the
top cover where the battery will not interfere with any components.
Peel off the backing of the tape and stick it to the chosen location.
!
!
6. The top should now be installed by using the two remaining 3/16"
screws. Make sure the L-brackets are aligned properly and secure the
top to the L-brackets.
!
!
7. Locate the four (4) rubber feet. Remove each of them from the
adhesive strip one at a time and stick one on each corner on the bottom
of the chassis. These are to keep the VEC-821K from sliding around
on the desktop.
