Quickstart USB-Interface
5.
Install IntCon
Installation
1. Download IntCon from
.
2. Extract / install the content of the archive to C:\Program
Files\IntCon\.
1. Connect the USB-
Interface with your PC.
2. Double-click on
intcon.exe to open IntCon.
3. Mark the USB-Interface
in the table
(Name RC USB,
Vendor MFTech).
4. Click
“
Open
”
.
5. Configure the USB-Interface.
Start
http://www.mftech.de/software.htm
6.
Configure the Interface
7.
irmware
Update f
1. Plug the Interface into the PC.
2. Start IntCon
USB-Interface is listed.
3. Double click the Interface, check "Activate Bootloader".
4. Click
“
Apply
”
and close the window.
5. If you unplug the Interface and reconnect it again, a new joystick
named
“
Loader
”
is detected. Windows will install new drivers for it. After
a delay of 10 seconds the boot loader disappears and the normal
“
RC USB
”
joystick is back again. The boot loader will always start
directly before the normal joystick after connecting. If you want to switch off the boot loader
(e.g. after a successful firmware update) then uncheck
“
Activate Bootloader
”
.
6. Now you can update the firmware with the
“
Firmware...
”
button. Connect the Interface, do
“
Erase
”
, then
“
Program
”
(and optionally
“
Verify), then
“
Reset
”
.
“
LED
”
causes the Interface to
toggle the LED. This is just for communication test purpose.
Software for the Interface is located at
→
http://forum.mftech.de
8.
Further informationen
Website:
this quickstart:
detailed instruction manual:
MFTech . Ralf Kretschmann . Kaiserstraße 25a . 67722 Winnweiler
info@MFTech.de . www.MFTech.de
http://www.mftech.de
http://www.mftech.de/quickstart_en.pdf
http://www.mftech.de/usb-interface.pdf
5.3.2007
Set up joystick buttons automatically:
- 1. button controlled by 5th R/C channel
- 1. button controlled by 3rd R/C channel
- all buttons off
Set up joystick axis
automatically:
- Throttle/ aileron right
- Throttle left, ailerons right
- Throttle right, ailerons left
- Throttle/ ailerons left
Set up joytick buttons
manually:
Button is triggered by
selected R/C channel
Button is triggered if R/C
channel exceeds this limit
Set up axis manually:
Axis is controlled by the
selected R/C channel
Invert direction of motion
of the axis
Set up mixers
Set up buttons manually:
I
Button can be triggered or
is always off
nvert the state of the button
Write configuration
to the RC-Interface
Read configuration
from the RC-Interface
store configuration
in the RC-Interface
Close window
Save settings
in file
Read settings
(for transmitter/
simulators)
from file
